Post Image

LI7500A

The LI7500A is LI-COR's open-path, high-speed, high-precision, nondispersive-infrared gas analyzer (IRGA). It accurately measures the in-situ densities of carbon dioxide and water vapor in turbulent air structures. I...

Show More
Post Image

Fuel Moisture and Temperature Accessories

10824 Fuel Moisture Stick The 10824 10-hour Fuel Moisture Stick is used with the CS505 Fuel Moisture Sensor. The 10824 is constructed from the same carefully selected USFS-standard ponderosa dowel as the traditional weig...

Show More
Post Image

CS205

Automated fuel temperature measurements can be made with our CS205/107 sensor. To measure fuel temperature, both the CS205 fuel temperature stick and the 107 temperature probe are required. The CS205 is a ponderosa pine ...

Show More
Post Image

GPS Sensor Accessories

17212 Magnetic Mount The 17212 magnetic mount allows the GPS16X-HVS to be attached to a magnetically susceptible metallic surface—typically the CM235. Three screws are included for attaching the GPS16X-HVS to the 17212 m...

Show More
Post Image

GPS Receivers

GPS16X-HVS GPS Receiver The GPS16X-HVS GPS receiver is the update to the GPS16-HVS. It consists of a receiver and an integrated antenna. This sensor receives signals from orbiting global positioning system (GPS) satellit...

Show More
Post Image

255-100

The 255-100 determines evaporation rate by measuring the changing water level in an evaporation pan. This evaporation gauge consists of a float, pulley, and counterweight attached to a precision 1000-ohm potentiometer mo...

Show More
Post Image

CS110

The CS110 Electric Field Meter measures the vertical component of the atmospheric electric field. It is used in research applications for measuring the local electric field and for lightning warning applications. The CS1...

Show More
Post Image

Electrical Current Sensors

CS10-L Current Transducer The CS10 uses CR Magnetic's CR8459 Current Transformer to measure the approximate current over a range of 0 to 200 Amps. The CS10 outputs a millivolt signal allowing the transducer to be dir...

Show More
Post Image

DMM600

The DMM600 measures volumetric water content of organic forest floor material. It is a portable, battery-powered device that uses measurement methods sensitive to the dielectric properties of the material being measured....

Show More
Post Image

CS511-L

The CS511 is a rugged, low-maintenance sensor that is manufactured by Sensorex. It consists of a self-polarizing galvanic cell that generates a millivolt signal proportional to the amount of oxygen present in the measure...

Show More