3WHB10K Half-Bridge Module

The 3WHB10K provides the completion resistor required for a 3-wire half bridge measurement. The completion resistor has a resistance of 10 kOhms with a tolerance of ±0.01%.

Features

Connects directly into datalogger input terminals; "prongs" on lower surface are secured into datalogger screw terminals
Makes accurate measurement of 3-wire Half Bridges simple, typically used with 100 and 1000 Ohm PRTs.

Specifications

Completion Resistor (Rf) (bulk metal foil): 10 kΩ
Tolerance @ 25°C: ±0.01%
Maximum Temperature Coefficient: ±0.8 ppm/°C
Power Rating: 0.25 W @ 70°C

4WHB10K Half-Bridge Module

The 4WHB10K provides a completion resistor for 4-wire half-bridge measurements. This module should be used with sensors that have a 10 kOhm resistance.

Features

Connects directly into datalogger input terminals; "prongs" on lower surface are secured into datalogger screw terminals
Makes accurate measurement of 10 kOhm, 4-wire half-bridges simple; gauges are measured with a 4-Wire Half Bridge instruction

Specifications

Completion Resistor (bulk metal foil): 10 kΩ
Tolerance (@ 25°C): ±0.01%
Maximum Temperature Coefficient: ±0.8 ppm/°C
Power Rating: 0.25 W @ 70°C

Producing Area:USA