41003-5 10-Plate Radiation Shield

The 41003-5 is a naturally aspirated 10-plate radiation shield. Its louvered construction allows air to pass freely through the shield, keeping the probe at or near ambient temperature. The shield's white color reflects solar radiation.

Features

Provides a naturally aspirated radiation shield
Protects an HMP45C or HMP35C when exposed to sunlight
Mounts directly to our tripods and towers
Replaces the 41002 12-Plate Gill Radiation Shield
Manufactured by RM Young

Specifications

The 41003-5 attaches to a crossarm, mast, or user-supplied pipe with a 1.0" to 2.1" OD.

41303-5A Radiation Shield

The 41303-5A is a naturally aspirated 6-plate radiation shield. Its louvered construction allows air to pass freely through the shield thereby serving to keep the probe at or near ambient temperature. The shield's white color reflects solar radiation.

Features

Provides a naturally aspirated radiation shield
Used with HMP50, CS215, CS500, 107, or 108 probes
Mounts directly to our tripods and towers
Replaces our 41303 6-Plate Gill Radiation Shield
Manufactured by RM Young

Specifications

The 41303-5A attaches to a crossarm, mast, or user-supplied pipe with a 1.0" to 2.1" OD.

43502-L Compact Aspirated Shield

The new 43502 Compact Aspirated Shield from R. M. Young features a more compact size, easier mounting, and lower cost than the 43408 aspirated shield that it replaces. Using a continuous blower, it draws ambient air over the sensor while protecting the sensor from the interference of solar radiation. The result is more accurate temperature and humidity measurement.

Features

The 43502 shield is usually used with the 43347 RTD probe, but can accommodate temperature and humidity sensors up to 0.9-inch diameter. The mounting bracket included on the shield attaches to posts or masts up to 2 inches in diameter.

Specifications

Aspiration Rate: 5 to 11 m s-1 (16 to 36 fps) depending on sensor size
Ambient Temperature: <0.2°C (0.4°F) RMS at 1000 W/m2 intensity)
Delta T: <0.05°C (0.1°F) RMS with like shields equally exposed
Power Required: 12 to 14 Vdc @ 500 mA for blower
Mounting: V-Block and U-Bolt for vertical pipe with 1.0” to 2.0” (2.5 to 5.0 cm) diameter

UT6P 6-Plate Radiation Shield

The UT6P is a naturally aspirated 6-plate radiation shield. Its louvered construction allows air to pass freely through the shield thereby keeping the probe at or near ambient temperature. The shield's white color reflects solar radiation.

Features

Provides a naturally aspirated radiation shield
Used with CS500, 107, or 108 probes
Requires UT018 to mount to UT10, UT20, or UT30 Towers

UT12VA 12-Plate Radiation Shield

The UT12VA is a naturally aspirated 12-plate radiation shield. Its louvered construction allows air to pass freely through the shield, keeping the probe at or near ambient temperature. The shield's white color reflects solar radiation.

Features

Provides a naturally aspirated radiation shield
Used with HMP45C or HMP35C
Requires UT018 to mount to UT10, UT20, or UT30 Towers

Producing Area:USA