The SDM-SIO1 module connects to Campbell Scientific dataloggers using the SDM port and communications protocol. It connects to a remote serial device using industry standard hardware that can be set to true RS-232, RS-48...
The SDM-CVO4 is a synchronously addressed datalogger peripheral that outputs variable voltage or current signals under datalogger program control. Each output can be set to 0-10 Vdc or 0-20 mA by the datalogger program (...
The SDM-AO4 provides four independent continuous analog outputs (0 to +5 Vdc) for proportional control or strip charts. Current sourcing capability is 125 µA. It requires the connected devices to have input impedances in...
The AM25T sequentially connects up to 25 thermocouples or other low-level voltage output sensors to a common differential channel. The output from this channel is wired to a differential input channel on the datalogger. ...
The AM16/32B has replaced the AM16/32A. The AM16/32B supports two clocking modes: Mode A works like the AM16/32A and sequentially advances through each channel. Mode B uses a relay address to go directly to a specific ch...
One CR9041 A/D module is included with each of our CR9000X-series and CR9000-series dataloggers. It provides amplification and signal conditioning for 16-bit, 100 kHz analog-to-digital (A/D) conversions. The CR9041 may b...
One CR9011 Power Supply Module is included with each CR9000X, CR9000XC, CR9000, or CR9000C datalogger, and is available as a replacement item. The CR9011 provides regulated power to the CR9000(X) from the internal batter...
The CR9032 is the 32-bit CPU module contained in a CR9000X Measurement and Control System. It provides system control, data processing, and communications. This module features a clock speed of 180 MHz, and includes an R...
The 10034 retrofit kit includes the enclosure and chassis components needed to retrofit a full CR9000X system to a smaller CR9000XC system; you can also use this kit to convert a CR9000 to a CR9000C. The 10034 does not i...
The CR9071E is a Pulse Module for the CR9000X-series or CR9000-series Measurement and Control Systems. It has 16 digital I/O channels and 12 pulse counting channels that can measure frequencies up to 1 MHz. All 28 channe...
