The SC-USB allows Campbell Scientific dataloggers to communicate directly with computers that have a USB interface. The SC-USB is optically isolated, which helps eliminate noise pickup associated with PC power supplies and ground connections. The SC-USB can be used in place of an SC32B interface.

Features

Supports ME, SDC, and CSDC protocols
Transfers data at rates up to 1 Mbps
Does not require an SC32B Interface

Specifications

Power: Drawn from the PC and datalogger
Current Drain
Drawn from Datalogger: <1 mA standby, <20 mA active
Drawn from PC: <18 mA standby, <85 mA active
Campbell Scientific Protocols Supported: Modem-Enable (ME), Synchronous Device Communications protocol (SDC) and Concurrent-SDC (CSDC) modes. Some of these modes may require that the datalogger operating system be a specific version or higher. The SDC mode only works with operating systems created since October 2002 (CR10X 1.18 or higher, CR23X 1.15 or higher, etc.) The CSDC mode only works with a PakBus (PB) operating system and the CR5000.
Communication Rates:
Asynchronous: 9600 bps to 115 kbps
Synchronous: up to 1 Mbps
CS I/O Port: Opto-isolated (signal isolation only) from the PC’s USB port to 47 Vac or dc
17648 Cable Description: 6-ft (1.8 m) length; type-A male to type-B male

Producing Area:USA