Campbell Scientific replaced the CR200-series dataloggers with the CR200X-series dataloggers. The new dataloggers feature expanded memory for the program and operating system (OS). The expanded memory allows:

Up to 128 public variables instead of 48
Up to eight tables instead of four
Compiled CRBasic programs that are two times larger
Like their predecessors, the CR200X-series dataloggers are small, lower-cost devices. The CR200X is our lowest-cost datalogger. Its input channel configuration and small size make it optimal for measuring one or two sensors. When paired with an ENC200 enclosure and the small 16869 battery, the packaged CR200 has a deployment size of only 6 inches by 7 inches.

The CR200X is the base model in the CR200 datalogger series. Three related models, the CR206X, CR211X, and CR216X, carry onboard, spread-spectrum radios, and the CR295X is specially equipped for use with the TX312 GOES transmitter.

Features:
Ideal where only a few sensors will be measured
Stores 128,000 data points (non-volatile)
6 Kbyte program storage (non-volatile)
Data format is table-based
Available operating systems: PakBus®
Software support offered in SCWin 2.0, PC400, or LoggerNet 3.x
Specifications
Current Drain: ~0.2 mA quiescent,~ 3 mA active
A/D Bits: 12
Scan Rate: once per second (max)
Analog Channels: 5 single-ended (no differential), individually configured
Analog Voltage Range: 0 to 2500 mV
Analog Voltage Accuracy: ±(0.25% of reading +1.2 mV off set), -40° to +50°C
Measurement Resolution: 0.6 mV
Switched Excitation Channels: 2 voltage
Switched Battery Port: 1
Pulse Count Channels: 2
Control Ports: 2
Memory: up to 19.6 kB (compiled program), 512 kB (data storage), 106 kB (operating system)
Communication Port: 1 RS-232
Protocols Supported: PakBus (leaf node only), SDI-12
Warranty: 3 years

Producing Area:USA